Posts Tagged ‘Canon cameras’

Many people have asked about repairing their front covers/flaps on their Canon PowerShot SD series cameras, so I’ve written up some instructions. Our lens barrier repair kit is a little tricky to replace on Canon SD series cameras but definately not impossible for you to do yourself. You will need patience, a good eye and a steady hand as well as a small screwdriver. We use dental picks, they work great!

To start, you will need to turn on the camera and extend the lens, then open the battery door to turn off the camera and keep the lens out. This allows you to easily work on the lens barrier assembly.

First the part we need is the ‘barrel drive ring’, it’s the ring with the small piece that sticks down into the lens. Most cameras have a drive ring, but some do not. If you don’t see one in your kit then your camera does not need one. Be certain that it will rotate slightly after installation, otherwise it is probably not installed properly and can cause the lens to get jammed.

Next we will install the barrier plates or ‘flaps’ with the springs attached. There is a small little tab that holds the spring in place when you put it on the ‘flap’ or ‘barrier plate’ as they are actually called. They are TINY, they are hard to hold and if you drop it… please take my advice and don’t drop it, ok? If you do lose some springs, we have them available on their own in our store for you to purchase.

Gently put the flap in the hole with the spring laying towards the post that the free end will mount on; then with something with a very small tip (we use dental picks!) gently grab the loop of the spring and stick it on its post.

If you do this with the lens covers or ‘flaps’ in the open position they will stay in place once you get them properly seated. If everything pops off, just start again. Try not to stretch out the springs, they need to remain tight for the assembly to work properly.

Then gently put on the barrier cover, it’s a flat plastic ring. The tabs on the outer barrier cover match up with small slots in the lens housing and it will lock into place. Be gentle, don’t force anything too hard or you will break it and the parts will not hold it place.

Now it’s time to test your skills! Now we put the battery in and while crossing our fingers, turn the camera on! Did it work? Did it go flying across the room with a cute little *SPROING!* and maybe all the parts scattered all over the place? I hope not, but you’re not alone I’ve been there too.

Once you have it working smoothly …you’re almost done with your first camera repair!

Next put the dual sided tape on the barrier cover. VERY IMPORTANT: Peel the tape off the yellow backing paper but DO NOT remove the paper from the side that is cut to match the shape of the tape!! If you take off the small paper part it will ruin the tape because it will fold and stick to itself. Bye bye tape!

The tabs of the tape fold over the edges, if they stick out the lens cover will not fit properly and can jam up the lens. Line up the tape tabs, starting at the 11 o’clock position and then fold down the tabs and press them in.

Now put on your chrome or black lens cap, line up the cap with the small indentation at the bottom, you’ll see how it goes on easily.

Fire up the camera again and admire your handywork! Congratulations you now know more about Canon camera repair than the Geek Squad, and they told you it would be two hundred dollars and take 3-4 weeks to repair. Whatever Geek Squad… Whatever.

Hmm… I think I’m seeing the beginning of something big here; affordable do it yourself Canon digital camera repair